[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 11/05/03 at 5:40 PM
Posted by: MAC@HI POINTE WELD EQPT REPAIR
E-mail: MACANDROB[AT55]AOL.COM (replace [AT55] with @ to reply)

In Reply to: Miller MP 65e to lincoln Ln8 posted by scott on 11/05/03 at 2:28 PM:

yes it can be done, do u have a cable with the 9 pin amphenol that screws into back of ln-8, the 14 pin end is not going to be used, if u are not electrically adept, take it to a shop, ln-8 tech manual will show u how to hook up, 120 volts(from round female receptacle on welder front panel) goes to c and d into 9 pin amphenol, in amphenol jumper d to a, going back to welder(male round receptacle), c and b will send 120 volts back to close welder contactor, this will power feeder and close welder contactor, a wire from the sort of moon shaped slot on female receptacle on welder is safety(earth) ground goes to 9 pin amphenol pin i, good luck brother

Follow Ups:

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: