[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 10/29/03 at 8:36 AM
Posted by: mac@hi-pointe weld eqpt repair
E-mail: macandrob[AT55]aol.com (replace [AT55] with @ to reply)

In Reply to: Re: Wire feeder for PowCon 300 ss posted by tedboch on 10/29/03 at 8:25 AM:

yes thats exactly what i'm talking about, getting proper wire speed matched with low weld output voltages, roughly 14 to 17 volts, some people can tune in feeder to voltage setings, but i've seen others who could not make it work, so all u can do is try, hope it doesntcost u alot to try, good luck

Follow Ups:

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: