|
|
Main Menu
Find
[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]
-
Date: 10/27/03 at 8:35 AM
Posted by: mac@hi pointe weld eqpt repair
E-mail: macandrob[AT55]aol.com (replace [AT55] with @ to reply)
-
In Reply to: Re: Troubleshooting a Miller Big 40 Welder posted by R Forbes on 10/25/03 at 10:13 PM:
the resistor u are looking for is roughly under gas tank close to center lifting hook, wire numbers attached to resistor should be 90 and 51, it is important to keep the resistors movable band in or very close to the same spot, this sets your open circuit voltage for weld output, if not sure resistor is good or bad, use jumper wire and hook it on wire 90 and 51, just for test purpose only!!!
Follow Ups:
Re: Troubleshooting a Miller Big 40 Welder R Forbes Posted at: 10/29/03
(4)
Re: Troubleshooting a Miller Big 40 Welder mac @hi-pointe weld eqpt repair Posted at: 10/30/03
(3)
Re: Troubleshooting a Miller Big 40 Welder R Forbes Posted at: 10/30/03
(2)
Re: Troubleshooting a Miller Big 40 Welder mac@ hi pointe rerpair Posted at: 10/30/03
(0)
Re: Troubleshooting a Miller Big 40 Welder mac/hi-pointe weld eqpt repair Posted at: 10/30/03
(0)