| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Welding/Metallising for Maintenance and Repair Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: needed :wiring dia. tig h.f. tig starter made by century

Date: 09/22/03 at 9:27 PM
Posted by: larry
E-mail: lair_86[AT55]yahoo.com (replace [AT55] with @ to reply)
Message Posted:

In Reply to: Re: needed :wiring dia. tig h.f. tig starter made by century posted by Jeff on 09/14/03 at 2:13 PM:

thanks jeff
the primary is 120 volt , the secondary is 3500 volt.then there is another inductor,wound with flat copper strip.in the winding there is three partial windings(a simple capacitor ?)I've got what appears to be a stable, even arcing at the point gaps,with the gaps cleaned and set to about 0.007 thou.when i strike an arc with no argon,it will carry across about half an inch,but with no intensity,i.e. very little current,even with the primary welder set at 100 amps.is this normal?again thanks for any info larry


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.