| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Welding/Metallising for Maintenance and Repair Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Miller 250G (portable) govenor

Date: 07/17/03 at 3:44 PM
Posted by: Jeff
E-mail: ventureline@shaw.ca
Message Posted:

In Reply to: Miller 250G (portable) govenor posted by bill on 07/16/03 at 10:55 AM:

Whoops I just gave you the info on a SA250 Lincoln.
So don't use that info!!!

Instead pull the top cover, remove the Idle soliniod and clean the rod and soliniod with emery. Often Miller doesn't check the position of the solinoid assembly, I've seen alot of machines with the solinoid on an angle with the idle rod, so it tends to rub, and stick on the housing. So when you put it back in check and align the rod with the solinoid.

Again NEVER screw with the Governor. I think your idle is still 38 - 43Vdc, high idle is around 70Vdc in DC+

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.