| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Welding/Metallising for Maintenance and Repair Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: rebuilding of table liners for cement industry

Date: 10/26/02 at 11:59 PM
Posted by: Buford Blevins
E-mail: CallmeBuford@aol.com
Message Posted:

In Reply to: rebuilding of table liners for cement industry posted by Vijay Deshpande on 08/24/02 at 2:39 AM:

Get away from the flux core due to the cost is to high,try a 3/16 110 hard facing rod as i have found this rod to be great on hard surfaces that indure atlot of wear and tear and you can stack the welds much higher than any other chrome rod and you dont have to preheat but it is recomended that you do,good luck. Blevins Mobile Welding Service


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.