[ List Subjects ][ Post Message ]
Subject: Powcon 300ST
[ View Followups ][ Post Followup ]
Date: 12/27/01 at 11:07 PM
Posted by: Dax Ulch
I have aquired a powcon 300st stick/tig welder without the manual. The neat thing is that it can run on 460 or 230 in one or three phase. The welder was setup in 460 3ph until I changed the buss bars over to 230. My question is, there were 4 wires leading into the welder, 3 going to the circuit breakers for phase and 1 ground. Now that I want to use 230 1ph which 3 wires for 230 go where?
Post a Follow-up: