| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Welding/Metallising for Maintenance and Repair Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Powcon 300ST

Date: 12/27/01 at 11:06 PM
Posted by: Dax Ulch
E-mail: daxulch@aol.com
Message Posted:

I have aquired a powcon 300st stick/tig welder. The neat thing is that it can run on 460 or 230 in one or three phase. The welder was setup in 460 3ph until I changed the buss bars over to 230. My question is, there were 4 wires leading into the welder, 3 going to the circuit breakers for phase and 1 ground. Now that I want to use 230 1ph which 3 wires for 230 go where?

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.