| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Servodrives and Servomotors Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Vexta Stepper Motor; 2 phase/.9degree step - PH268M-E1.5

Date: 06/27/02 at 4:56 PM
Posted by: John Reep
E-mail: the_reep_o_man@hotmail.com
Message Posted:

I don't know how to go about asking for some help... but, I am doing a project for the University of Mississippi... and this project deals with microcontrollers (specifically a PIC 16F873) and a stepper motor to rotate a telescope. To not go into to much detail, i've built the program needed but I can't seem to get the stepper motor to step.. I'm guessing that it is most likely due to the fact that I probably don't have the rihgt signals in the right place. I can't find any data sheets for this... but if anyone might just happen to know what arrangements the wires needed to be connected in... please help. by the way, I'm using a bimos chip to rotate the stepper. Thank you for your time.

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.