[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 12/24/02 at 4:53 PM
Posted by: jim
E-mail: jimw46@yahoo.com

In Reply to: Re: Can I wire a Vexta Stepper to run without a contoller??? posted by Randy on 01/24/02 at 8:47 PM:

Steve:
you can use a vexta 5 phase stepper with an xy table and an electolysis pen connected to the z axis. Lay down on the table and don't move. The Acme hair matrix import program will remember the location of each hair and when the run button is pushed, it will electolyize each hair to within .1mm, which is why you can't move during the process. If your machine runs any software written by Bill Gates I would not attempt to remove any butt hair.

Follow Ups:

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: