| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Questions?????

Date: 07/15/02 at 5:51 PM
Posted by: Neal
E-mail: ndebiasio@fadal.com
Message Posted:

In Reply to: Re: Questions????? posted by danny on 07/15/02 at 1:33 AM:

Danny--
It will be necessary to set your paramaters in the Fanuc control to the proper data
bits, parity, and stops bits. Check your control manual for the proper settings. Also you'll need to set the baud rate parameter. These same setting will then also need to be set up in your communications software's parameters.

You'll need to get an RS-232 communications cable connected between your computer and and your machine. Once you can establish a data link between the two, then just follow the prompts in your DNC software.

NEal


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.