| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Threading a large dia. metal ring

Date: 06/28/02 at 1:16 PM
Posted by: Neal
E-mail: ndebiasio@fadal.com
Message Posted:

In Reply to: Threading a large dia. metal ring posted by Darryl Weaver on 06/27/02 at 6:21 PM:

The quickest and easiest solution to this problem is to replace the hard top jaws with aluminum soft jaws. Using a spider, machine the jaws to properly hold your part and then machine an ID clearence relief for the threading tool to go beyound the part some reasonable amount.


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.