| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Machining ID and OD of Thin Walled Tube

Date: 06/14/02 at 2:39 AM
Posted by: Bill
E-mail: wbfsh@yahoo.com
Message Posted:

In Reply to: Machining ID and OD of Thin Walled Tube posted by Mahmud Syaltut on 01/29/02 at 1:02 AM:

I have made a sleeve out of a piece of nylon that was about 2" bigger in diameter. With an exact fit over the o.d. of the tubing then I split one side of the sleeve and slip it over the tubing and chuck on the nylon sleeve to cut the i.d.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.