| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Fanuc O-T Parameters

Date: 10/28/03 at 4:09 PM
Posted by: Steven
E-mail: bcnitefly@aol.com
Message Posted:

In Reply to: Fanuc O-T Parameters posted by Tony on 10/17/03 at 9:10 AM:

I'm not sure of the parameter numbers, but have you tried just reseting them by holding in P and Cancel at control power up, This resets them for Manual return purposes..

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.