| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Fanuc OTD help needed.

Date: 10/07/03 at 2:35 AM
Posted by: Adi
E-mail: m4r74d1@yahoo.com
Message Posted:

In Reply to: Fanuc OTD help needed. posted by Xan Das on 10/01/03 at 10:05 PM:

It's depend on where do you want to write the number. If you use CAM software, it's possible to write inside CAM software, before postprocessing.

The second way, you write on controller after transfering via DNC.

hope it's helped.


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.