| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Milling 440 stainless steel

Date: 08/13/03 at 12:14 AM
Posted by: Libor Pírko
E-mail: libor.pirko@aero.cz
Message Posted:

In Reply to: Milling 440 stainless steel posted by daryl bane on 04/20/03 at 9:19 PM:

Problems are from speed, feed and angle on tools no cooling. You must use very positive angel. Look on this pages - forum. There are a lot of informations about machning of stainless steel. Good luck. Libor Pírko

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.