| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: FAPT user questions

Date: 08/03/03 at 5:59 PM
Posted by: Anonymouse
E-mail: Anon@anon.com
Message Posted:

In Reply to: FAPT user questions posted by Bill on 05/19/03 at 8:56 AM:

FAPT is very easy conversational control. It produces no canned cycles just pure gcode longhand. Its very fast and you should have no problems with it. You may need to look at the manual for selecting the right tool, but other than that its self explanatory.

Canned cycles on the 10-T are the same as older fanuc 0Ts.

Similar to newer 0Ts except for using I and K instead of R and one line G76 instead of Two...


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.