| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Hooking up Funuc OT control to PC.

Date: 05/15/03 at 1:53 PM
Posted by: jaime
E-mail: jubeinext@yahoo.com
Message Posted:

In Reply to: Re: Hooking up Funuc OT control to PC. posted by DungQT on 05/14/03 at 5:56 AM:

I found the wire diagram.

As follows:

RS 232 cable config
25pin to 9 pin
Fanuc Computer
1 --shield 1
2 ---------------- 2
3 ---------------- 3
4 --| 4
5 --| -- 5
|--6 / 6
| 7 -----ground-/ 7
|--8
|--20

at the fanuc end, pins 4 and 5 should be jumpered together and pins 6, 8 and 20 should be jumpered together.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.