| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Hooking up Funuc OT control to PC.

Date: 05/14/03 at 5:56 AM
Posted by: DungQT
E-mail: dungqt@yahoo.com
Message Posted:

In Reply to: Hooking up Funuc OT control to PC. posted by Jaime on 05/13/03 at 12:28 PM:

Buy a 25pin female to 9pins adapter connector
make a cable with 25pins female connector on one end and 9pins connector on another end.
Do you have wire diagram?

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.