| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Good finish on OD , Facing - help reqd

Date: 04/23/02 at 12:16 PM
Posted by: jason
E-mail: carbide76@yahoo.com
Message Posted:

In Reply to: Good finish on OD , Facing - help reqd posted by sumit jain on 04/20/02 at 11:50 AM:

Try adding more tool clearance by rotating the tool post 30 degrees. Also make sure the cutting edge of the tool is on the same centerline axis as the work piece being turned.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.