[ List Subjects ][ Post Message ]
Subject: Re: Using conventional Lathe to make Crankshaft!
[ View Followups ][ Post Followup ]
Date: 04/21/02 at 6:52 AM
Posted by: Tom
In Reply to: Using conventional Lathe to make Crankshaft! posted by Ron on 03/20/02 at 6:30 AM:
While the crankshafts are roughly blanked by forging, the journals are indeed turned. I think strength would be an issue for most steels to be used in an engine but that's a non-educated opinion.
Post a Follow-up: