| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Good finish on OD , Facing - help reqd

Date: 04/20/02 at 11:50 AM
Posted by: sumit jain
E-mail: matoind@hotmail.com
Message Posted:


i am using WNMG 06T408 - wf insert from ISCAR.

It is a wiper insert.

When i do the turning at 260 m/min with a fees of 0.22mm/rev
the turning is fine on the outer dia, but when i do the facing, the finish becomes like rubbing towards the centre.

Max RPM is 3000. I think it is not able to get the sufficient rpm.

does anyone have any suggestion?

sumit jain

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.