| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Parts for emco v10p lathe

Date: 11/14/02 at 8:43 PM
Posted by: avid Bono
E-mail: davidromayne@earthlink.net
Message Posted:

In Reply to: Re: Parts for emco v10p lathe posted by Jim Briante on 08/28/02 at 11:41 PM:

I replaced the ac motor on my maximat 7 about 2 years ago. I use a 48 frame 1/2 hp 3 phase motor powered with a 1/2 hp vfd drive. The difference in operating has been remarkable. Fingertip control of speeds, along with the gear changes, gives you a speed range down to crawl.
get rid of the cumbersome emco switchgear.

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.