| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Fadal Questions

Date: 04/09/01 at 6:31 PM
Posted by: JAMES
E-mail: RMWALKUR@AOL.COM
Message Posted:

In Reply to: Re: Fadal Questions posted by Neal on 12/29/00 at 1:56 PM:

THE SHOP I WORK IN HAS BEEN OFFERED A JOB TO RUN 100 SHAFT'S A MONTH THEY ARE 15 INCHES AND HAVE A CAM ON EACH END ONE INCH LONG. THEY HAVE TO BE IN TIME WITH EACH OTHER WITHIN .002 . THE CAM IS OFF SET .375 FROM CENTER . STARTING WITH A 2.00 INCH SHAFT AND CUTTING THE CAM TO .990 . THE PROBLEM IS HOW TO INDEX THE SHAFT AND REMAIN IN TIMMING,WE HAVE A SMALL CENTER WITH A 2.00 THRU HOLE ANY HELP WILL ,,,,,,HELP ..THE COMPANY THAT WANT'S THIS DONE HAS TOLD US THEY ARE HAVING THIS DONE FOR A COST OF $37.00 A SHAFT ,,THE STEEL COST US $14.00 EACH CAN YOU OFFER ANY HELP??


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.