| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: rough threads

Date: 03/19/01 at 12:45 PM
Posted by: Neal
E-mail: ndebiasio@fadal.com
Message Posted:

In Reply to: rough threads posted by Bob M on 03/18/01 at 8:33 AM:

Bob--
There are two major things that I have seen cause this. The first is too low an RPM. If your surface feet are not high enough then instead of cutting, the thread tool scrapes the material off leaveing a finish that appears that it has hairs on it.
Another problem could be that the tool is above centerline and the bottom clearance is negated causing the tool to rub instead of cut.

Neal


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.