| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Lathe Tool Holders.. need input

Date: 03/09/01 at 9:42 PM
Posted by: Jim
E-mail: jrwheels16@aol.com
Message Posted:

In Reply to: Lathe Tool Holders.. need input posted by Dr G on 03/07/01 at 2:42 PM:

Try the PH Horn Mini system, Vardex Boring or Iscar's Chamgroove system. They offer a bar with an insert that screws on the end of it. The inserts are available in threading, boring, grooving, facegrooving. Go to www.iscarmetals.com or www.vnecorp.com They will fit into 7/16" bore diameter.

Good Luck,


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.