| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Tapping

Date: 08/15/00 at 7:33 AM
Posted by: The Virtual Machinist
E-mail: vmachinist@csonline.net
Message Posted:

In Reply to: Tapping posted by Duane S. on 08/14/00 at 7:26 AM:

This is my personal opinion but I prefer to use tension
& compression method if available it seems to be the best method and will allow for not so perfect tapping. I have used this method on both horizonal and vertical mills.
Like I said this is my prefrence only good luck
Bill


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.