| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: ISO tooling for Derbyshire Micromill

Date: 04/22/02 at 12:21 PM
Posted by: Yasmiin Davis
E-mail: yasmiin@gte.net
Message Posted:

In Reply to: Re: ISO tooling for Derbyshire Micromill posted by Len Bejtlich on 03/19/02 at 6:26 PM:

I have one of these mills. I sure would like to find the indexing attachment and the vise that were available for the mill. I would also like to find the vertical version of the MicroMill.

Also lookung for milling arbours.

The Micromill takes a 10MM Jewelers lathe collets. They are available in #1 to # 80 as well in fractional sizes. There collets are available new from Derbyshire who are still in business. Unfortunatly the mill is not made any longer.

Its a bit unclear as to wheather you have the vertical or the horizontal version of the mill. In any even a collet is available that will hold your end mill.

However, for horizontal milling you would generally use a milling arbour and small horizontal milling cutters.


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.