| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: N.I.M.S.job skills for lathe and mill?

Date: 03/05/02 at 5:08 PM
Posted by: Tony Tammer
E-mail: tony@trainingmachinists.org
Message Posted:

In Reply to: Re: N.I.M.S.job skills for lathe and mill? posted by Andy Pettican on 01/07/02 at 7:40 PM:

NIMS standards are being touted in the U.S. as a way to standardize the qualifications of machinists. As Director of Training at the National Tooling & Machining Ass'n Training Center, Fremont, CA, I have big problems with them. They are not suited to West Coast manufacturing, but seem to come out of the rust belt. For instance, Horizontal mill is listed as a competency, but you can barely find any on the West Coast. I gave a lot more reservations than this, but I'll leave off here.
Tony Tammer


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.