| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: taps with through coolant hole

Date: 02/15/02 at 5:34 PM
Posted by: Andy
E-mail: Andypttcn@aol.com
Message Posted:

In Reply to: Re: taps with through coolant hole posted by B.S.saini on 08/08/01 at 1:35 PM:

Yes but dont forget if tapping a blind hole a through coolant tap will wash the swarf out of the hole. This could be a big plus on the quality front and also maybe negate a cleaning op later.

Regards

Andy


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.