[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 02/04/02 at 7:28 PM
Posted by: Kenneth David Allen
E-mail: jeeperscompshop2000@yahoo.com

In Reply to: Machining Polypropylene posted by Leo on 01/26/02 at 10:41 AM:

Leo:
Go to this site, it might be helpfull.

http://www.matweb.com/measurements/deflection-temperature.htm

We also used to take some plastic and put it in a preheated (Blue M) oven at low temperatures for about 15 minutes and let it relax. Then you take it out and let it cool slowly at room temperature.
Ken.

Follow Ups:

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: