[ List Subjects ][ Current Board ][ Post Message ]
Subject: Machining Polypropylene
[ View Followups ][ Post Followup ]
Date: 01/26/02 at 10:41 AM
Posted by: Leo
Hello, After machining aprox. 40 rectangular pockets, measuring 1.0in.x 1.5in.x .100dp. into a sheet of
Polypropylene that measured 20in.x 20in.x3/4in.thick, the material cupped and bowed out of shape.
Is there any method to stress relive (I use stress relive for a lack of better terminology) this material back to where it will lay somewhat flat?
Post a Follow-up: