| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Prototrac Edge 2 Post processor for Mastercam

Date: 01/25/02 at 5:44 PM
Posted by: otherside pc
E-mail: theflopside@hotmail.com
Message Posted:

In Reply to: Prototrac Edge 2 Post processor for Mastercam posted by Matt on 03/30/01 at 2:20 PM:

i have been using mastercam -> mprotmx2.pst post -> 1.44 mb floppy, ibm format -> edge get .mx2 ...

the file names can be only numbers and must end in ".mx2" and can be only 500 events or less! to engrave our logo and a part number it takes about four programs of 500 events each ... BTW, anybody have a single line True Type Font? i haven't found one yet....

it works for me, good luck....

.jms.420.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.