| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: does any one know of a pc program to learn cnc programing

Date: 12/17/01 at 4:55 PM
Posted by: Mick Barton
E-mail: Mick@torc.softnet.co.uk
Message Posted:

i need to learn to program cnc lathes with fanuc systems iv been a tool setter on autoes for 27 years & would like to learn more at home on the pc i have p111 800mhz 256ram 20 gig ultra dma 720 speed hard drive running win 98 i think this should run about anything does any one know where i can et such a program or down load regards mick

Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.