| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Drill Sizes

Date: 11/01/01 at 9:46 AM
Posted by: Neal
E-mail: ndebiasio@fadal.com
Message Posted:

In Reply to: Drill Sizes posted by Lance on 10/25/01 at 12:24 PM:

Lance--
The most obvious answer to your question is that both are made available to obtain consistancy in the numbering sequences both letter and fractional. A complete set of A thru Z would not run consistance if one letter, E in this case, were missing. Same holds true for the fractional size sequence.
Remember that everything that we do in live isn't necessarily the smartest or most practical. Sometimes life itself is much easier if we just accept what is!

Neal


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.