| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: True Position

Date: 09/24/01 at 9:30 AM
Posted by: Neal
E-mail: ndebiasio@fadal.com
Message Posted:

In Reply to: Re: True Position posted by Andy on 09/22/01 at 8:28 AM:

Andy --
Normally a true position call out is in reference to a hole. The true position of the center of the hole would be independant of the tolerance of the size of the hole.


Follow Ups:

Post a Follow-up:


Message to Post:


1999-2001 Sunlit Technology Co., Ltd. All rights reserved.