| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: True Position

Date: 09/21/01 at 5:30 PM
Posted by: Neal
E-mail: ndebiasio@fadal.com
Message Posted:

In Reply to: Re: True Position posted by Neal on 09/21/01 at 5:21 PM:

Andy-- Try this. A true position of .0254 mm means that if you draw a circle of .0254mm diameter around the target spot, then the cutting action MUST take place within that circle. Does that make sense?Neal


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.