[ List Subjects ][ Current Board ][ Post Message ]
Subject: Re: can I bore dia 155 mm in aluminium using a ISO 30 spindle
[ View Followups ][ Post Followup ]
Date: 08/23/01 at 9:17 AM
Posted by: Neal
In Reply to: Re: can I bore dia 155 mm in aluminium using a ISO 30 spindle posted by Andy Pettican on 08/23/01 at 3:29 AM:
Since I'm not privy to the british tolerence specs,H7 didn't mean enough to me. As you pointed out, in this case circular interpolation would be more than adequate.
If you have any printed data on the machining specs from your part of the woods, I would appreciate it if you would consider educating me!
Post a Follow-up: