[ List Subjects ][ Current Board ][ Post Message ]
Subject: Re: can I bore dia 155 mm in aluminium using a ISO 30 spindle
[ View Followups ][ Post Followup ]
Date: 08/23/01 at 3:29 AM
Posted by: Andy Pettican
In Reply to: Re: can I bore dia 155 mm in aluminium using a ISO 30 spindle posted by Neal on 08/22/01 at 6:13 PM:
Yes Neal I agree with your reply but as the tolerance required was to H7 which on a 155 dia hole is -0.000mm ton +0.040mm then circular interpolation is more than adequate.
Also in a general machine shop who can measure roundness to 0.005mm. In this instance I consider that a boring process is over engineering.
Post a Follow-up: