| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Looking for small threaded bushings for wire stripper

Date: 06/27/01 at 5:03 PM
Posted by: Mark Biederbeck
E-mail: mbiederb@pcc.edu
Message Posted:

I am looking for some "off the shelf" threaded bushings to act as a nosecone for a power hand-held wire stripper being designed to strip small wires (28-16 awg). If you've ever used a manual or automatic pull-riveter, they have small threaded cones that are changed out for the diamter or rivet you are using. The three features are: a hex head to put a wrench around, a threaded body, and an appropriately sized hole. These need to be small, about a 1/4-28 thread or smaller with holes ranges from about .030" to about .130". Overall length about 3/8". Any suggestions? Don't need to many so looking for a standard item.

Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.