| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Milling and Turning Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Turner and engineer!!

Date: 05/08/01 at 5:39 PM
Posted by: col
E-mail: cols@bigfoot.com
Message Posted:

In Reply to: Re: Turner and engineer!! posted by Ron on 04/24/01 at 2:46 AM:

That is the accepted way, but in my experience the designer turns out a drawing. The turner deciphers it, spots any mistakes and corrects them!Then the process of manufacture is decided. If needed, liason with the milling section is used to ensure that the right process is attained. The prototype part (or first off) is checked and if necessary, sent to the customer for approval.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.