[ List Subjects ][ Current Board ][ Post Message ]
Subject: Lathe Gearbox Seal Problem - Schaerer 18x60
[ View Followups ][ Post Followup ]
Date: 05/07/01 at 9:40 PM
Posted by: Gary L Peterson
The spindle seals are leaking alot, so we have been trying to figure out how to remove the spindle and replace them.
Only manuals found are $150 each set of (5)= $750!!! and are in German.
The spindle has a calibrated worm gear adjustment on the chuck side (inside the gearbox).
We can't figure out how this one comes apart!
Post a Follow-up: