| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > Instrument Design Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: Circuit for Metex 4630

Date: 05/22/03 at 8:37 PM
Posted by: Ray
E-mail: rrogers@plaidheron.com
Message Posted:

In Reply to: Circuit for Metex 4630 posted by Grey Wolf on 05/22/03 at 9:07 AM:

I tried Sam's photofax and found nothing, then I tried the web and found only one mention!
Let's think though:
1) Have you checked for a blown fuse? Of course that could be hard without a resistance checker:)
2) The process is to apply a voltage across the resistor and measure the current (or vic versa). Do you have a voltage coming out of the terminals in the resistance mode?
The older digital multimeters just digitized a voltage that was generated by some analog circutry. Perhaps you could track down the drive; or if that works, apply a voltage to the terminals in resistance mode and try to track down a bad part.
Did this make sense to you?
I actually wouldn't put much hope in just poking around; but if you want a hobby.

Ray


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.