[ List Subjects ][ Current Board ][ Post Message ]
Subject: Post-processor Robcad Kuka
[ View Followups ][ Post Followup ]
Date: 03/08/01 at 3:36 PM
Posted by: Rich
I have to create a post-processor for a Robonum800 (controller made by Schneider Electric) that controls a Kuka robot. The controller uses a type of g-code. The CAM program is Robcad (eM-Power) which produces the simulation.
Does anybody have any experience with this? I'm not a programmer and I have the feeling I will have to use awk which uses a c type of syntax.
Post a Follow-up: