| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Industrial Robotics Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Motoman ERC Weld interface board I/O

Date: 04/09/01 at 8:54 AM
Posted by: Rick Maule
E-mail: goonio@yahoo.com
Message Posted:

Can anybody confirm the following I/O reference the Honda style plug on the weld I/O board
Pin 1,2 wire stick +ve & -ve, pin 3 weld voltage ref, 5,12,17 0volt common, 15 wire feed speed set, 19 weld start.

I would be grateful if anyone could tell me where the arc establish signal should be connected too.

Regards

Rick


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.