| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > PSpice Models for Analog & Digital ICs Message Board > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Simulating Buck Convertor using PSPICE

Date: 07/10/02 at 1:22 PM
Posted by: Adit
E-mail: avaidya2@acsu.buffalo.edu
Message Posted:

I'm trying to generate a triangular/sawtooth wave from a Buck convertor, but my voltage-controlled switch is not performing repeated transitions. How do I adjust the threshold voltages so the convertor actually "switches"? Should I replace the switch with a comparator or a Schmidt Trigger (if so what are the part numbers?).

Note: My buck convertor consists of a load resistor and inductor. Also, it has a diode running from the series resistance to ground.

Thank you for your help!


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.