| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Electrical and Electronic Community > X-ray Generation Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: x-ray transformer terminal identification

Date: 03/23/01 at 10:24 PM
Posted by: Bill DiSantis
E-mail: bdisantis5555@yahoo.com
Message Posted:

In Reply to: Re: x-ray transformer terminal identification posted by Mike Gray on 03/23/01 at 4:49 PM:

Mike,Thanks for the reply. I forgot about dual filament tubes- that is most likely what those XF id's mean. I think you're right about the A/AA values.... when a very low voltage is applied across these terminals, some 500 volts is measured on the output side. I'll keep you posted as to what happens.Bill


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.