| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Foundry Technology Forum > Message
Main Menu
Find

[ List Subjects ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: gas holes in steel castings

Date: 07/21/03 at 7:31 AM
Posted by: C Ponnu
E-mail: c_ponnu@yahoo.com
Message Posted:

In Reply to: gas holes in steel castings posted by jayanthi on 07/01/03 at 12:53 PM:

Checking the mould coat is the first step

Have a look at the moulding practice for the smaller bodies. May be you are achieving enough mould/core compaction with higher sizes. 45 degree is the most likely position to have porosity as o degree has parting line and 90 degree has direct compaction. Allow gases to escape at this area.

Hope this helps.


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.