[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Date: 06/29/00 at 9:29 PM
Posted by: Lee
E-mail: laseymour@email.msn.com

In Reply to: Re: A casting of aluminum with a copper tube posted by Lance on 05/31/00 at 10:08 PM:

Lance:

I know you are looking for a solid block, but if you were to make the block in halves, you could mold the holes in a number of different forms including a spiral around the heater insert (using cores). Facing off the surfaces would give you a good seal and the internal holes could be tapped right into the block for external fittings.

Follow Ups:

Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post: