| Home | Terms of Use | Site Map | Contact Us |
IndustryCommunity.com > Manufacturing Community > Foundry Technology Forum > Message
Main Menu
Find

[ List Subjects ][ Current Board ][ Post Message ]
[ View Followups ][ Post Followup ]

Subject: Re: design on air Vents for gravity dies to cast aluminium

Date: 07/08/01 at 10:30 AM
Posted by: pradeep anjaria
E-mail: piston@vsnl.com
Message Posted:

In Reply to: design on air Vents for gravity dies to cast aluminium posted by alonso de la garza on 06/30/01 at 8:29 AM:

1. make holes and insert a pin (plug) slit 0.5mm throught the diameter.ensure a gap is seen by placing a torch light on one side to check.

2. air vents should generally be placed in the area where machining has to be done, other wise on the long run u shall find occurrence of flash.

3. what component and material, do u want air venting to be done.

regards

pradeep


Follow Ups:


Post a Follow-up:

Name:
E-Mail:
Subject:

Message to Post:

 

1999-2001 Sunlit Technology Co., Ltd. All rights reserved.